What are the special properties of steel metal abrasives compared to ordinary raw materials?
Quality is both image and promise.--Product Brief
Our Steel metal raw material products are engineered for high-volume metal surface processing and industrial pretreatment. We supply both spherical steel shot for low-stress polishing and angular steel grit for high-impact cleaning, covering common shot sizes (S70–S390) and grit ranges (G10–G120), with options for customized hardness, chemistry, and packaging.
Controlled metallurgy, heat treatment, and particle-classification processes give consistent impact energy, service life, and low contamination. For wholesale partners we provide scalable supply (monthly capacities into millions), on-site process tuning (intensity, throughput, cleanliness), and full traceable QA documentation (chemical analysis, Rockwell/Vickers hardness, PSD and microstructure reports). These solutions improve coating adhesion, cut rework, and increase line throughput.
Decisions based on facts produce repeatable outcomes.--Product Definition
- Steel Shot Polishing is spherical steel particles produced by casting/rolling and heat treatment, used for peening, polishing, oxide removal and coating preparation. Spherical shape reduces localized stress and is suited for surface strengthening and finishing.
- In contrast, the shape of steel grit sands are angular steel particles with sharp edges delivering concentrated impact energy for aggressive scale removal, derusting, and cast/forged burr cleanup.
Key controllables: chemistry (C, Si, Mn), heat-treatment hardness (set per process), particle-size distribution (affects surface profile and coverage), cleanliness (fines/oil/iron filings), and moisture control in packaging.
Not hype,data.--Product Advantages
Predictable impact energy for repeatable surface results
PSD and hardness control enable customers to target specific intensity and surface profile ranges, producing reproducible finishing or peening characteristics.
Custom metallurgy & hardness to suit processes
Typical hardness offerings span roughly 40–60 HRC (subject to contract and lab verification), balancing service life vs. aggressiveness; third-party chemical and hardness reports available.
Low friability and extended service life → lower total cost
Optimized cooling and recycling reduces breakage and dust, lowering waste and maintenance.
Tight particle sizing → consistent coverage and throughput
PSD reports with each lot help engineering teams predict cycle time and coverage.
Traceable industrial QA
Lot-level documentation-chemistry, hardness, PSD, moisture, and contamination-supports incoming inspection and third-party audits.
On-site process tuning to reduce rework
We provide intensity, nozzle/distance, throughput, and screening recommendations based on sample trials.
Results speak louder than ads.--Customer Case
Challenge:
Improve coating adhesion for axle components and cut rework.
Solution:
G40 angular Steel Grit Blasting for heavy derusting, followed by S230 shot for profile control with standardized recycling. PSD and hardness reports supplied per lot.
Outcome:
Adhesion tests showed an average improvement of ~25% vs baseline; rework decreased and line throughput rose ~12%. Full third-party lab reports and sample data available under NDA or with sample trials.
Good support makes partnerships last.--Warranty & Support
Traceability: Lot-level QA (chemistry, hardness, PSD, moisture).
Response: Nonconformity acknowledged within 3 days; Sample return and third-party retest available.
Process support: Steel shot/grit sand-blast intensity, recycling/screening and dust control guidance to extend service life and reduce downtime.
Warranty: Replacement/compensation for manufacturing defects per contract, SLAs for long-term partners.
